ReadMyHeart measures the electrical activities emitted by the heart. The “Noise” is the interference with the recording of these signals due to poor contact between the thumbs and the electrodes, excessive movement of the body, and other the environment, etc. When using ReadMyHeart, it is recommended that users take a stable sitting position, with their feet insulated from the ground. Please measure again when “Noise” appears on LCD screen after the device finishes recording. For detailed operating procedure, please refer to P.9 of the User’s Manual.

Besides the factors mentioned in Q2, the followings are some of the factors that may also affect measurements:
1. Thumbs may be greasy, which may affect the transmission of signals. Please use clean water to clean thumbs.
2. Thumbs may be too dry. DO NOT use cream. Please use external auxiliary electrode cable & sticky electrode pad.
3. Contact pressure between the thumbs and the electrodes may be too strong. Please place thumbs on the electrodes gently.
Even when users have followed the regular procedure described in the User’s Manual to operate ReadMyHeart, the user may still experience a weak signal. Please contact the distributor, retailer, or visit DailyCare BioMedical’s website: Hwww.dcbiomed.com.
 

The optional auxiliary electrodes are for users who cannot hold ReadMyHeart steadily without shaking, or users whose thumbs are too dry. For detailed instructions, please follow the steps described in P.10 of the User’s Manual. Please note that the electrode pads are NOT included. Please buy the electrode pads from a medical device store.

During the 25 seconds measurement, ReadMyHeart cannot be stopped or powered off.

Data cannot be managed on the ReadMyHeart device directly. If there is more than one user, please use the software provided for data management. For detailed information, please refer to the User’s Manual.

Data cannot be managed on the ReadMyHeart device directly. If there is more than one user, please use the software provided for data management. For detailed information, please refer to the User’s Manual.

The rise in temperature is caused by the improper direction of the poles of the batteries when inserted. Please remove the batteries quickly and then reinsert the batteries correctly. Please allow the ReadMyHeart to drop to a normal operating temperature before making any measurements.

The ECG tracings recorded by ReadMyHeart is not for clinical diagnostic purposes. It is only to be used for physician’s reference, and to be used for personal home care health management.

Data will remain in the memory for approximately 2 minutes only during battery replacement. Thus, please replace batteries as quickly as possible to preserve data.